Create the “Yeah Yeah” Bodyrox synth in Reason 4.0! (Tutorial)

Steps:

• First create a Thor synthesizer.
• Set the polyphony to 4And the release polyphony to 1
• Now select mono retrig under keyboard modesSelect on for the portamento
• Now click show programmer so we can actually get this synth rollingIn the first oscillator leave it as an analog and move the octave to 3
• Now turn the little knob below tune and make sure its a t OSC 1 PW 64
• On Oscillator 2 add another Analog Oscillator, the octave should be set at 4 and the semi should be set at 4
• Set the tune knob to 11
• Once again turn the knob under tune and set it to OSC 2 PW 64
• Now add a third Analog oscillator. The octave will be 2.
• This time switch the type of synth from the downhill line to the squiggly one
• And turn the knob under tune to OSC 3 PW 64
• On your low pass Ladder Filter make sure 123 are selected
• Now lets move over to the filter envelope
• Set a to 1.9 d to 349 s to -48.2 and R to 705
• On the amp envelope set a to 1.2 d to 349 s to 0 and r to 1.09
• Now we are going to make the sound change for your modulation wheel, for source go to performance and click mod wheel, set the amount to 64, and for destination go to filter 1 filter frequency
• Now add a BV512 Vocader switch the fft knob to 4 band and switch the knob from vocader to equalizer
• Switch the decay to 127
• Move the shift to -30move the hf emph to o and the dry wet to 127
• Now create a RV7000 Advanced Reverb and select all warm plate
• Now enable the eqSet the decay to 0 the HF damp to 25 the hi eq to -4 and the dry wet to 18
• Now create an mclass equalizer and selct the 30 hz lo cut button
• On the lo shelf set the frequency to 106.2 and the gain to 1.7
• Now select the button on param 1 and set the frequency to 114.9
• The gain to 4.6 and the q to 4.9Next create a mclass maximizer and set the input gain to 6Select the 4ms look ahead button
• Set the second fast button to auto
• And switch the peak button to vu