10 thoughts on “Custom White Akai APC40 Controller

  1. THanks very much for the feature guys, been a reader of this site for a long time, so it was really cool to see a pingback on my blog to here for my APC40 paintjob.

    David (Auditory Canvas).

  2. Remove the rubber feet underneath, and undo all the screws underneath them. Then undo all the main screws on the circuit board. Then remove the knob caps, and undo the nuts on each encoder.
    Then remove the 3 screws on each side cheek on the inside of the housing. The 3 allen screws on the outside of each cheek don't actually do anything, so don't undo them and try and take the cheeks, off, you'll break it. They are held on from the inside.

  3. Remove the rubber feet underneath, and undo all the screws underneath them. Then undo all the main screws on the circuit board. Then remove the knob caps, and undo the nuts on each encoder.
    Then remove the 3 screws on each side cheek on the inside of the housing. The 3 allen screws on the outside of each cheek don't actually do anything, so don't undo them and try and take the cheeks, off, you'll break it. They are held on from the inside.

  4. i need to replace a up fader on my apc 40 i kicked it by accident
    is theyre any where with step by step instructions on how to do this
    thanks

Leave a Reply to Enigmafon records Cancel reply

Your email address will not be published. Required fields are marked *