Super Saw Synth For Windows

Super Saw Synthesizer

Adam Szabo has released JP6K, a new virtual synthesizer instrument for Windows that’s dedicated to emulating the famous Super Saw sound, first found in the Roland JP-8000 synthesizer in 1997:

The original Super Saw from Roland was aliasing, thus creating a bright and “airy” sound. To prevent the sound from sounding harsh below the fundamental harmonic, a high pass filter was possibly used to remove the unwanted frequencies. The JP6K uses the same design to achieve that special oscillator waveform giving it a unique tone.

Another important aspect of the classic Super Saw, was its special detune curve. It was non-linear, which gave the user greater control over the detune amount. Even when the detune control was half way, the spread of the detune was small, which made it possible to make very smooth sounding pads. The curve then gradually increased, and at higher values, the detune rapidly spread out to maximum. This unique curve is accurately modelled in JP6K, making it nearly identical to the detune in the hardware.

The JP6K also emulates other features from the JP-8000 like the filters, key tracking and the EQ, to give it an even more authentic way to shape the Super Saw sound. The synth has been optimised to use minimal amount of CPU, so it is possible to use multiple instances.

Features:

  • 32 voice polyphony.
  • Two Super Saw oscillators, an upper and lower.
  • 1 noise oscillator.
  • Three filter modes: low pass, band pass and high pass with -12 & -24 dB/Oct.
  • Three independent LFOs controlling the filter, amp and pitch.
  • Built in delay and EQ.

Does it make the classic super saw trance sounds? Check out the audio demo below:

JP6K for Windows is available now for $25 EUR.  A demo version is available.

10 thoughts on “Super Saw Synth For Windows

Leave a Reply to DJmonikr Cancel reply

Your email address will not be published. Required fields are marked *