Help locating part

[Dan131313]

Hello folks. I am really very sorry about this but I'm sure it will get a quick answer and then this post can be ignored. I tried a search and I have googled in an attempt at not annoying anyone but here goes...

I have a dark energy and want to make my own glide pot as I don't fancy paying £20 for a pot and a couple of bits of wires! I cannot for the life of me find the name of the component which connects the jumper cables to the PCB as seen in the picture below.

http://www.glitched.org/up/wp-content/uploads/2010/11/100_1220.jpg

Massively embarrassed to ask but know that I have been looking for a couple of months now!

[altitude909]

are you talking about the connector or the jumper in that pic? The connector looks like a standard 2 pin 0.100" connector, anything that meets that spec will work. The jumper (aka jumper shunt) is also 0.100 spaced by the looks of it